LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls/Fuel - 1.8L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Evaporative Emission Canister Purge Solenoid Valve
    GM2373054Courtesy of GENERAL MOTORS COMPANY
  1. Install the evaporative emission canister purge solenoid valve (2) to the bracket (1).
  2. Remove the cap from the fuel tank vent pipe.
    3. Fig 2: Evaporative Emission Pipe And Evaporative Emission Canister Purge Solenoid Valve
    GM2373052Courtesy of GENERAL MOTORS COMPANY
  3. Connect the wiring harness plug (3) to the evaporative emission canister purge solenoid valve (2).
  4. Install the evaporative emission pipe (1) to the evaporative emission canister purge solenoid valve (2).
  5. Remove the cap from the evaporative emission pipe.
    6. Fig 3: Fuel Tank Vent Pipe And Evaporative Emission Canister Purge Solenoid Valve
    GM2372982Courtesy of GENERAL MOTORS COMPANY
  6. Install the fuel tank vent pipe (2) to the evaporative emission canister purge solenoid valve (1) and to the clip (3).
  7. Connect the battery negative cable Battery Negative Cable Disconnection and Connection .
  8. Close the hood.
scientia non olet · About LEMON Manuals