LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - M32) >> Repair Instructions - On Vehicle >> Transmission Mount Bracket Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Install the 3 exhaust flexible pipe to catalytic converter nuts and lower the exhaust flexible pipe. Refer to Catalytic Converter Replacement (LUJ) , Catalytic Converter Replacement (LUW) .
  3. Support rear of powertrain using a suitable jack stand.
    4. Fig 1: Transmission Rear Mount Bolt
    GM2191538Courtesy of GENERAL MOTORS COMPANY
  4. Remove transmission rear mount bolt (1).
    5. Fig 2: Transmission Rear Mount And Bolts
    GM2191539Courtesy of GENERAL MOTORS COMPANY
  5. Remove 3 transmission rear mount bolts (1).
  6. Remove transmission rear mount (2).
scientia non olet · About LEMON Manuals