LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - M32) >> Repair Instructions - On Vehicle >> Transmission Mount Bracket Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Transmission Rear Mount And Bolts
    GM2191539Courtesy of GENERAL MOTORS COMPANY
  1. Install transmission rear mount (2).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install 3 transmission rear mount bolts (1) and tighten to 100 N.m (74 lb ft).
    3. Fig 2: Transmission Rear Mount Bolt
    GM2191538Courtesy of GENERAL MOTORS COMPANY
  3. Install transmission rear mount bolt (1) and tighten to 100 N.m (74 lb ft).
  4. Remove jack stand.
  5. Install the 3 exhaust flexible pipe to catalytic converter nuts. Refer to Catalytic Converter Replacement (LUJ) , Catalytic Converter Replacement (LUW) .
  6. Lower vehicle.
scientia non olet · About LEMON Manuals