LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - M32) >> Repair Instructions - On Vehicle >> Transmission Mount Bracket Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the battery tray. Refer to Battery Tray Replacement .
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Install the engine support fixture. Refer to Engine Support Fixture , for the 1.4L engine or Engine Support Fixture for the 1.8L engine.
  4. Lower the vehicle.
    5. Fig 1: Transmission Mount Bolts
    GM2191491Courtesy of GENERAL MOTORS COMPANY
  5. Remove and DISCARD 3 transmission mount bolts (1).
    6. Fig 2: Transmission Mount Nuts And Bolts
    GM2191492Courtesy of GENERAL MOTORS COMPANY
  6. Remove 2 transmission mount bolts (1, 3) and transmission mount nut (2).
    7. Fig 3: Transmission Mount
    GM2191493Courtesy of GENERAL MOTORS COMPANY
  7. Remove the transmission mount (1).
    8. Fig 4: Transmission Mount Bracket And Bolts
    GM2191520Courtesy of GENERAL MOTORS COMPANY
  8. Remove 3 transmission mount bracket bolts (1).
  9. Remove the transmission mount bracket (2).
scientia non olet · About LEMON Manuals