LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - M32) >> Repair Instructions - On Vehicle >> Transmission Mount Bracket Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Transmission Mount Bracket And Bolts
    GM2191520Courtesy of GENERAL MOTORS COMPANY
  1. Install the transmission mount bracket (2).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install 3 transmission mount bracket bolts (1) and tighten to 100 N.m (74 lb ft).
    3. Fig 2: Transmission Mount
    GM2191493Courtesy of GENERAL MOTORS COMPANY
  3. Install the transmission mount (1).
    4. Fig 3: Transmission Mount Nuts And Bolts
    GM2191492Courtesy of GENERAL MOTORS COMPANY
  4. Install 2 transmission mount bolts (1, 3) and tighten to 62 N.m (46 lb ft).
  5. Install the transmission mount nut (2) and tighten to 62 N.m (46 lb ft).
    6. Fig 4: Transmission Mount Bolts
    GM2191491Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Torque-to-Yield Fastener Caution .

  6. Install 3 NEW transmission mount bolts (1) and tighten to 50 N.m (37 lb ft) plus 60-75 degrees.
  7. Raise the vehicle.
  8. Remove the engine support fixture.
  9. Lower vehicle.
  10. Install the battery tray. Refer to Battery Tray Replacement .
scientia non olet · About LEMON Manuals