Filling Procedure
WARNING: This page is about a different variant/trim than selected.
- Lower the vehicle.
- Without disconnecting the electrical connector, unclip the engine control module with the bracket from the battery tray and hang aside.
- For 1.4L gasoline engine, refer to Engine Control Module Replacement .
- For 1.8L gasoline engine, refer to Engine Control Module Replacement .
- Remove the fluid fill plug (1).
- Compare the amount of fluid drained to the transmission refill capacity. Fill the transmission with the appropriate amount of fluid. Refer to Manual Transmission Specifications .
- Install the fluid fill plug (1) and tighten to 30 N.m (22 lb ft).
- Clip in the engine control module.
- For 1.4 gasoline engine, refer to Engine Control Module Replacement .
- For 1.8 gasoline engine, refer to Engine Control Module Replacement .
NOTE:
Prior to the removing of any plug, clean the surrounding area of the plug.
NOTE:
This transmission is NOT equipped with a fluid level dipstick or oil level setting plug. The fluid level can only be checked by performing the draining and filling procedure.