LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - M32) >> Repair Instructions - On Vehicle >> Manual Transmission Shift Lever and Selector Lever Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove transmission control. Refer to Transmission Control Replacement .
  2. Remove battery tray. Refer to Battery Tray Replacement .
    3. Fig 1: Selector Lever Cable, Bracket And Transmission Control Housing
    GM2191413Courtesy of GENERAL MOTORS COMPANY
  3. Using a suitable pry tool, carefully remove shift lever and selector lever cable (2) from transmission control housing (3).
  4. Remove shift lever and selector lever cable from shift lever and selector lever cable bracket (1).
    5. Fig 2: Selector Lever Cable
    GM2191408Courtesy of GENERAL MOTORS COMPANY
  5. Remove shift lever and selector lever cable (1) from bulkhead.
  6. Remove shift lever and selector lever cable from inside the engine compartment.
scientia non olet · About LEMON Manuals