LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - M32) >> Repair Instructions - On Vehicle >> Front Wheel Drive Shaft Seal Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove left front wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement - Left Side .
    2. Fig 1: Front Differential Carrier Flange, Bolts And Washers
    GM2191397Courtesy of GENERAL MOTORS COMPANY
  2. Remove and DISCARD 4 front differential carrier flange bolts (3) and 4 washers (2).

    Remove front differential carrier flange (1) from transmission.

    3. Fig 2: Front Wheel Drive Shaft Oil Seal, Front Differential Carrier Flange And Remover/Installer
    GM2191398Courtesy of GENERAL MOTORS COMPANY
  3. Remove front wheel drive shaft oil seal (1) from front differential carrier flange (2).

    Put front differential carrier flange on CH-466-A  remover/installer (5) and press front wheel drive shaft oil seal out of front differential carrier flange using DT-523-1  remover / installer (3) in conjunction with DT-523-3  remover / installer (4).

    4. Fig 3: Front Differential Carrier Flange And Seal
    GM2191399Courtesy of GENERAL MOTORS COMPANY
  4. Remove front differential carrier flange seal (2) from front differential carrier flange (1).
scientia non olet · About LEMON Manuals