LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - M32) >> Repair Instructions - On Vehicle >> Front Wheel Drive Shaft Seal Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Front Differential Carrier Flange And Seal
    GM2191399Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Coat front differential carrier flange seal with NEW transmission fluid.

  1. Install NEW front differential carrier flange seal (2) to front differential carrier flange (1).
    2. Fig 2: Front Differential Carrier Flange, Front Wheel Drive Shaft Oil Seal And Installer Drift
    GM2191400Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Coat front wheel drive shaft oil seal with NEW transmission fluid.

    Press front wheel drive shaft oil seal into front differential carrier flange using DT-519  installer drift (3).

  2. Install NEW front wheel drive shaft oil seal (1) to front differential carrier flange (2).
    3. Fig 3: Front Differential Carrier Flange, Bolts And Washers
    GM2191397Courtesy of GENERAL MOTORS COMPANY
  3. Install front differential carrier flange (1) to transmission.
    4. CAUTION:

    Refer to Fastener Caution .

    CAUTION:

    Refer to Torque-to-Yield Fastener Caution .

  4. Install 4 washers (2) and 4 NEW front differential carrier flange bolts (3) and tighten to 20 N.m +45° (15 lb ft +45°).
  5. Install left front wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement - Left Side .
scientia non olet · About LEMON Manuals