LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - M32) >> Diagnostic Information and Procedures >> DTC P0806-P0808 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. If DTC P0335, P0336, P0607, P0641, P0651 or P080A is set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
  2. Ignition ON, observe the scan tool CPP Sensor percent parameter. The percentage should vary from 0% when the clutch pedal is released, to 100% when the clutch pedal is in the apply position.
  3. Perform the CPP learn procedure. Refer to Clutch Pedal Position Sensor Learn .
  4. Operate the vehicle within the conditions for running the DTC to verify the DTC does not reset.
scientia non olet · About LEMON Manuals