Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Re-cut the 4 timing belt rear cover threads.
- Install the timing belt rear cover (1).
- Install the 4 NEW timing belt rear cover bolts (2) and tighten to 6 N.m (53 lb in).
- Install the timing belt tensioner. Refer to Timing Belt Tensioner Replacement .
- Install the camshaft position actuator adjuster. Refer to Camshaft Position Actuator Adjuster Replacement .
NOTE:
If the cover is contaminated with oil. You have to clean it close.
CAUTION:
Refer to Fastener Caution .
NOTE:
Service may offer bolts that are not microencapsulated. If this is the case apply thread lock agent to the bolt. If fastener is microencapsulated, install a NEW 4 timing belt rear cover bolts. DO NOT reuse the old bolt.