Engine Mount Replacement

WARNING: This page is about a different variant/trim than selected.

Fig 1: Engine Mount And Bolts

GM2191253

Courtesy of GENERAL MOTORS COMPANY

Engine Mount Replacement

Callout	Component Name
Preliminary Procedures Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement . Support the engine. Install a suitable engine lifting device. Install a suitable cable at the 3 engine lift brackets and at the engine lifting device.
1	Engine Mount Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 62 N.m (46 lb ft)
2	Engine Mount Bracket Bolt (Qty: 3) CAUTION: Refer to Torque-to-Yield Fastener Caution . Procedure Install NEW bolts, do NOT reuse old bolts Tighten 50 N.m + 60°-75° (37 lb ft + 60°-75°)
3	Engine Mount Nut Tighten 62 N.m (46 lb ft)
4	Engine Mount