LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.8L (LUW)) >> Repair Instructions - On Vehicle >> Drive Belt Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Drive Belt Routing
    GM2191162Courtesy of GENERAL MOTORS COMPANY
  1. Install the drive belt (1).
    2. Fig 2: Checking Drive Belt Position
    GM2547260Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Ensure that the drive belt is aligned on the generator pulley (4), crankshaft balancer (5), drive belt tensioner (6) water pump pulley (7), and A/C compressor. The drive belt must lie on the water pump pulley between the flange (1) and (2).

  2. Check the position of the drive belt (3).
    3. Fig 3: Drive Belt Tensioner And Special Tool
    GM2189264Courtesy of GENERAL MOTORS COMPANY
  3. Release tension to the tensioner by rotating counterclockwise (1).
    4. NOTE:

    Allow tensioner to slide back slowly.

  4. Remove EN 6349  pin (2).
  5. Apply tension to the tensioner clockwise (1).
  6. Install the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  7. Lower the vehicle.
  8. Close the hood.
scientia non olet · About LEMON Manuals