Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Replace the timing belt. Refer to Timing Belt Replacement .

Fig 1: Crankshaft Sprocket

Courtesy of GENERAL MOTORS COMPANY

Remove the crankshaft sprocket (1).

Fig 2: Crankshaft Front Oil Seal Removal Tool

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Clean the crankshaft sealing surface with a clean, lint-free towel. Inspect lead-in edge of crankshaft for burrs/sharp edges that could damage the rear main oil seal. Remove burrs/sharp edges with crocus cloth before proceeding.

Using the EN-45000 remover (3), remove the crankshaft front oil seal (1) from the crankshaft (2).