LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.8L (LUW)) >> Repair Instructions - On Vehicle >> Crankshaft Front Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Crankshaft And Crankshaft Front Oil Seal
    GM2373394Courtesy of GENERAL MOTORS COMPANY
  1. Clean the sealing surfaces.
  2. Slide the EN-6351  mounting sleeves (2) protective sleeve onto the crankshaft journal.
  3. Slide the crankshaft front oil seal (1) over the protective sleeve on the crankshaft journal.
    4. Fig 2: Crankshaft Drive Gear Bolt, Washer And Sleeves
    GM2373395Courtesy of GENERAL MOTORS COMPANY
  4. Remove the protective sleeve, and using the EN-6351  mounting sleeves (3), press the seal ring into the pump housing.
  5. Use the crankshaft drive gear bolt (1) and washer (2) to press in the crankshaft front oil seal.
    6. Fig 3: Crankshaft Sprocket
    GM2028278Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    When installing the crankshaft sprocket, the cam and the groove must align (2).

  6. Install the crankshaft sprocket (1).
  7. Install the timing belt. Refer to Timing Belt Replacement .
scientia non olet · About LEMON Manuals