LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.8L (LUW)) >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement (Manual Transmission) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Open the hood.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  4. Remove the drive belt. Refer to Drive Belt Replacement .
  5. Remove the transmission front mount. Refer to Transmission Front Mount Replacement .
    6. Fig 1: Connection Bolt
    GM2538035Courtesy of GENERAL MOTORS COMPANY
  6. Remove the bolted connection (1).
    7. Fig 2: Locking Device
    GM2547255Courtesy of GENERAL MOTORS COMPANY
  7. Install the EN-6625  locking device (2) to lock the crankshaft.
  8. Install the bolted connection (1).
    9. Fig 3: Crankshaft Balancer And Bolt
    GM2027569Courtesy of GENERAL MOTORS COMPANY
  9. Remove and DISCARD the crankshaft balancer bolt (1).
  10. Remove the crankshaft balancer (2).
scientia non olet · About LEMON Manuals