LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.8L (LUW)) >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement (Manual Transmission) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Crankshaft Balancer And Bolt
    GM2027569Courtesy of GENERAL MOTORS COMPANY
  1. Install the crankshaft balancer (2).
    2. CAUTION:

    Refer to Fastener Caution .

    CAUTION:

    Refer to Torque-to-Yield Fastener Caution .

  2. Install a NEW crankshaft balancer bolt (1) and tighten in 3 passes using the EN-45059  meter :
    1. First pass to 95 N.m (70 lb ft).
    2. Second pass to 45°.
    3. Third pass to 15°.
    3. Fig 2: Locking Device
    GM2547255Courtesy of GENERAL MOTORS COMPANY
  3. Remove the bolted connection (1).
  4. Remove EN-6625  locking device (2) to unlock the crankshaft.
    5. Fig 3: Connection Bolt
    GM2538035Courtesy of GENERAL MOTORS COMPANY
  5. Install the bolted connection (1) and tighten to 40 N.m (30 lb ft).
  6. Install the transmission front mount. Refer to Transmission Front Mount Replacement .
  7. Install the drive belt. Refer to Drive Belt Replacement .
  8. Install the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  9. Lower the vehicle.
  10. Close the hood.
scientia non olet · About LEMON Manuals