LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.8L (LUW)) >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement (Automatic Transmission) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Crankshaft Balancer And Bolt
    GM2027569Courtesy of GENERAL MOTORS COMPANY
  1. Install the crankshaft balancer (2).
    2. CAUTION:

    Refer to Fastener Caution .

    CAUTION:

    Refer to Torque-to-Yield Fastener Caution .

  2. Install a NEW crankshaft balancer bolt (1) and tighten in 3 passes using the EN-45059  meter :
    1. First pass to 95 N.m (70 lb ft).
    2. Second pass to 45°.
    3. Third pass to 15°.
    3. Fig 2: Locking Device And Bolt
    GM2027000Courtesy of GENERAL MOTORS COMPANY
  3. Remove the bolt (1).
  4. Remove EN-6625  locking device (2) to unlock the crankshaft.
    5. Fig 3: Automatic Transmission Bracket Bolt
    GM2538037Courtesy of GENERAL MOTORS COMPANY
  5. Install the bolt (1) and tighten to 45 N.m (33 lb ft).
  6. Install the drive belt. Refer to Drive Belt Replacement .
  7. Install the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  8. Lower the vehicle.
  9. Close the hood.
scientia non olet · About LEMON Manuals