LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.8L (LUW)) >> Repair Instructions - On Vehicle >> Camshaft Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the camshaft position actuator adjuster. Refer to Camshaft Position Actuator Adjuster Replacement .
    2. Fig 1: Camshaft Front Oil Seals And Tool
    GM2191650Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do not damage the sealing surfaces.

  2. Use the EN-45000  remover to loosen the camshaft front oil seals (1).
    3. Fig 2: Camshaft Front Oil Seals
    GM2189265Courtesy of GENERAL MOTORS COMPANY
  3. Remove the camshaft front oil seals (1).
scientia non olet · About LEMON Manuals