LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.8L (LUW)) >> Repair Instructions - On Vehicle >> Camshaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Camshaft Front Oil Seals
    GM2189265Courtesy of GENERAL MOTORS COMPANY
  1. Insert 2 NEW camshaft front oil seals (1).
    2. Fig 2: Camshaft Sprocket Bolt, Shims And Tool
    GM2373396Courtesy of GENERAL MOTORS COMPANY
  2. Tighten the seal ring with EN-422  installer (3) on the camshaft until this is in contact with the cylinder head.
  3. To install, use camshaft sprocket bolt (1) in conjunction with shims (2) with a total thickness of approximately 10 mm (0.393 in).
  4. Install the camshaft position actuator adjuster. Refer to Camshaft Position Actuator Adjuster Replacement .
scientia non olet · About LEMON Manuals