Timing Belt Rear Cover Installation

WARNING: This page is about a different variant/trim than selected.

Re-cut the 4 rear timing belt cover threads.

Fig 1: Timing Belt Rear Cover And Bolts

Courtesy of GENERAL MOTORS COMPANY

Install the timing belt rear cover (1).

CAUTION:

Refer to Fastener Caution .

NOTE:

Service may offer bolts that are not microencapsulated. If this is the case apply thread lock agent to the bolt. If fastener is microencapsulated, install a NEW 4 timing belt rear cover bolts. DO NOT reuse the old bolt.

Install the 4 NEW timing belt rear cover bolts (2) and tighten to 6 N.m (53 lb in).