LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.8L (LUW)) >> Repair Instructions - Off Vehicle >> Intake Manifold Installation

Intake Manifold Installation

WARNING: This page is about a different variant/trim than selected.
  1. Clean the sealing surfaces.
  2. Install 4 NEW gaskets.
    3. Fig 1: Intake Manifold And Bolts
    GM2026541Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Install the intake manifold (2) and the 7 intake manifold bolts (1) and tighten to 20 N.m (15 lb ft).
    4. Fig 2: Intake Manifold Brace And Bolts
    GM2026538Courtesy of GENERAL MOTORS COMPANY
  4. Install the intake manifold brace (1).
  5. Install the 2 intake manifold brace bolts (2, 3) and tighten to 8 N.m (71 lb in).
scientia non olet · About LEMON Manuals