LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.8L (LUW)) >> Repair Instructions - Off Vehicle >> Intake Manifold Assemble

Intake Manifold Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Intake Manifold, Multiport Fuel Injection Fuel Rail, Fuel Injectors, Seals And Bolts
    GM2373077Courtesy of GENERAL MOTORS COMPANY
  1. Install the 4 NEW multiport fuel injector seals (4).
  2. Install the multiport fuel injection fuel rail (2) and the fuel injectors (3) to the intake manifold (5).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the 2 multiport fuel injection fuel rail bolts (1) and tighten to 8 N.m (71 lb in).
    4. Fig 2: Intake Manifold, Evaporative Emission Canister Purge Solenoid Valve Bracket And Bolts
    GM2373076Courtesy of GENERAL MOTORS COMPANY
  4. Install the evaporative emission canister purge solenoid valve bracket (1) to the intake manifold (3).
  5. Install the 2 evaporative emission canister purge solenoid valve bracket bolts (2) and tighten to 7 N.m (62 lb in).
    6. Fig 3: Intake Manifold, Intake Manifold Seal And Throttle Body Seal
    GM2189145Courtesy of GENERAL MOTORS COMPANY
  6. Install the NEW intake manifold seal (3) to the intake manifold (2).
  7. Install the NEW throttle body seal (1).
    8. Fig 4: Intake Manifold And Mount
    GM2189144Courtesy of GENERAL MOTORS COMPANY
  8. Install the intake manifold mount (2) to the intake manifold (1) and tighten to 8 N.m (71 lb in).
    9. Fig 5: Intake Manifold, Manifold Absolute Pressure Sensor And Bolt
    GM2189143Courtesy of GENERAL MOTORS COMPANY
  9. Install the manifold absolute pressure sensor (2) to the intake manifold (3).
  10. Install the intake manifold absolute pressure sensor bolt (1) and tighten to 6 N.m (53 lb in).
scientia non olet · About LEMON Manuals