Ignition Coil Installation

Special Tools 

EN-6009  Remover/Installer Ignition Module

For equivalent regional tools, refer to Special Tools .

Fig 1: Ignition Coil Module And Special Tool
Courtesy of GENERAL MOTORS COMPANY
1. Install the ignition coil module (2) with the EN-6009  remover/installer (1).
2. Remove the EN-6009  remover/installer (1).
CAUTION:

Refer to Fastener Caution

NOTE:

Note the arrow on the cover.

3. Install the 2 ignition coil bolts and tighten to 8 N.m (71 lb in).
NOTE:

Note the arrow on the cover.

4. Install the cover of the DIS ignition coil against the direction of the arrow.