LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.8L (LUW)) >> Repair Instructions - Off Vehicle >> Engine Oil Cooler Housing Installation

Engine Oil Cooler Housing Installation

WARNING: This page is about a different variant/trim than selected.
  1. Clean the engine oil cooler housing to thermostat housing sealing surfaces.
  2. Install 2 NEW gaskets.
    3. Fig 1: Engine Oil Cooler Housing, Bolts And Engine Oil Cooler Inlet Pipe
    GM2026867Courtesy of GENERAL MOTORS COMPANY
  3. Install the engine oil cooler inlet pipe (3).
  4. Install the engine oil cooler housing (1) and the 5 engine oil cooler bolts (2) and tighten to 25 N.m (18 lb ft).
    5. Fig 2: Engine Oil Cooler Outlet Pipe And Bolts
    GM2026830Courtesy of GENERAL MOTORS COMPANY
  5. Install the thermostat housing coolant pipe (2) to the engine oil cooler housing.
  6. Install the 2 thermostat housing coolant pipe bolts (1) and tighten to 8 N.m (71 lb in).
scientia non olet · About LEMON Manuals