LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.8L (LUW)) >> Repair Instructions - Off Vehicle >> Engine Block Disassemble

Engine Block Disassemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Cylinder Head Locating Pins
    GM2026868Courtesy of GENERAL MOTORS COMPANY
  1. Remove the cylinder head locating (1, 2).
    2. Fig 2: Oil Pressure Switch
    GM2026870Courtesy of GENERAL MOTORS COMPANY
  2. Remove the oil pressure switch (1).
    3. Fig 3: Knock Sensor And Bolt
    GM2026869Courtesy of GENERAL MOTORS COMPANY
  3. Remove the knock sensor bolt (2) and the knock sensor (1).
  4. Clean the thread.
    5. Fig 4: Oil Flow Check Valve
    GM2026901Courtesy of GENERAL MOTORS COMPANY
  5. Remove the oil flow check valve (1).
    6. Fig 5: Oil Pressure Relief Valve Closure Bolt
    GM2026539Courtesy of GENERAL MOTORS COMPANY
  6. Remove the oil pressure relief valve closure bolt (1) and the oil pressure relief valve.
    7. Fig 6: Piston, Spring And Oil Pressure Relief Valve Closure Bolt
    GM2026540Courtesy of GENERAL MOTORS COMPANY
  7. Remove the piston (1) and spring (2) from the oil pressure relief valve closure bolt (3).
  8. Clean and inspect the components. Refer to Engine Block Cleaning and Inspection .
  9. Clean the thread.
    10. Fig 7: Piston Oil Nozzles
    GM2026902Courtesy of GENERAL MOTORS COMPANY
  10. Remove the 4 piston oil nozzles (1).
scientia non olet · About LEMON Manuals