LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.8L (LUW)) >> Repair Instructions - Off Vehicle >> Engine Block Assemble

Engine Block Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Piston Oil Nozzles
    GM2026902Courtesy of GENERAL MOTORS COMPANY
  1. Install the 4 piston oil nozzles (1).
    2. Fig 2: Piston, Spring And Oil Pressure Relief Valve Closure Bolt
    GM2026540Courtesy of GENERAL MOTORS COMPANY
  2. Install the piston (1) and spring (2) to the oil pressure relief valve closure bolt (3).
    3. Fig 3: Oil Pressure Relief Valve Closure Bolt
    GM2026539Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Install the oil pressure relief valve and the oil pressure relief valve closure bolt (1) and tighten to 21 N.m (16 lb ft).
    4. Fig 4: Knock Sensor And Bolt
    GM2026869Courtesy of GENERAL MOTORS COMPANY
  4. Install the knock sensor (1) and the knock sensor bolt (2) and tighten to 20 N.m (15 lb ft).
    5. Fig 5: Oil Flow Check Valve
    GM2026901Courtesy of GENERAL MOTORS COMPANY
  5. Install the oil flow check valve (1).
    6. Fig 6: Oil Pressure Switch
    GM2026870Courtesy of GENERAL MOTORS COMPANY
  6. Install the oil pressure switch (1) and tighten to 20 N.m (15 lb ft).
    7. Fig 7: Cylinder Head Locating Pins
    GM2026868Courtesy of GENERAL MOTORS COMPANY
  7. Install the cylinder head locating (1, 2).
scientia non olet · About LEMON Manuals