Crankshaft Balancer Removal

Special Tools 

EN-652  Flywheel Holder

For equivalent regional tools, refer to Special Tools .

Fig 1: Flywheel And Flywheel Holder
Courtesy of GENERAL MOTORS COMPANY
1. Install the EN-652  holder (1). Lock the flywheel (2) or the automatic transmission flex plate via the starter ring gear.
Fig 2: Crankshaft Balancer, Washer And Bolt
Courtesy of GENERAL MOTORS COMPANY
2. Remove and DISCARD the crankshaft balancer bolt (4).
3. Remove the crankshaft balancer washer (3).
4. Remove the crankshaft balancer (2).