LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.8L (LUW)) >> Repair Instructions - Off Vehicle >> Automatic Transmission Flex Plate Installation

Automatic Transmission Flex Plate Installation

WARNING: This page is about a different variant/trim than selected.

Special Tools 

EN-652  Automatic Transmission Flex Plate Holder

For equivalent regional tools, refer to Special Tools .

  1. Clean the automatic transmission flex plate bolt threads.
    2. Fig 1: Automatic Transmission Flex Plate And Holder
    GM2028106Courtesy of GENERAL MOTORS COMPANY
  2. Install the automatic transmission flex plate (2) and the EN-652  holder to hold the automatic transmission flex plate (2).
    3. Fig 2: Automatic Transmission Flex Plate And Bolts
    GM2028105Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    CAUTION:

    Refer to Torque-to-Yield Fastener Caution .

  3. Install the 6 NEW automatic transmission flex plate bolts (2) and tighten the bolts to 60 N.m (44 lb ft) ± 5°.
  4. Remove the EN-652  holder.
scientia non olet · About LEMON Manuals