LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.8L (LUW)) >> Diagnostic Information and Procedures >> Oil Pressure Diagnosis and Testing >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Switch off the engine.
  2. Remove the EN-232  adapter.
  3. Remove the EN-498-B  gauge.
  4. Install new closure bolt in the cylinder head.
    5. CAUTION:

    Refer to Fastener Caution .

  5. Tighten the closure bolt to 15 N.m (11 lb ft).
  6. If necessary, install the exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement (LUJ) , Exhaust Manifold Heat Shield Replacement (LUW) .
  7. Check the engine oil level.
scientia non olet · About LEMON Manuals