LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.8L (LUW)) >> Diagnostic Information and Procedures >> Cylinder Leakage Test >> Test Procedure

Test Procedure

WARNING: This page is about a different variant/trim than selected.
    NOTE:

    Follow manufacturer instructions.

  1. Calibrate the pressure loss tester and connect to the compressed air system.
    2. Fig 1: Pressure Loss Tester
    GM1937002Courtesy of GENERAL MOTORS COMPANY
  2. Install the pressure loss tester.
      NOTE:

      Wheels must be in contact with the ground.

    • Engage first gear and apply the parking brake.
    • Install the connecting piece into the spark plug thread of cylinder number 1.
    • Apply compressed air to cylinder number 1.
  3. Inspect for Pressure Loss
    • Take pressure loss reading.
      • The maximum permissible pressure differential between cylinders is approximately 10 percent.
      • Maximum pressure loss of a cylinder is 25 percent.
    • Take note of any visible escape of compressed air.

      Intake manifold, exhaust manifold, crankcase

    • Take note of any bubble formation in the coolant compensation tank.
  4. Perform pressure loss test by analogy on cylinders 3, 4 and 2.
scientia non olet · About LEMON Manuals