LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Wiper System & Washer System) >> Repair Instructions >> Washer Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Washer Pump Hose, Washer Pump Electrical Connector, & Washer Solvent Level Sensor
    GM815208Courtesy of GENERAL MOTORS CORP.
  1. Position the seal to the washer solvent container, pressing in until fully seated.
  2. Position the washer pump to the washer solvent container pressing, in until fully seated.
  3. Connect the washer pump electrical connector.
  4. Connect the washer pump hose.
  5. Install the front fender liner. Refer to Front Fender Liner Replacement .
  6. Fill the washer solvent container with washer solvent.
scientia non olet · About LEMON Manuals