LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Wiper System & Washer System) >> Diagnostic Information and Procedures >> Windshield Wiper Washer System Malfunction >> Component Testing >> Windshield Washer Fluid Pump

Windshield Washer Fluid Pump

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the windshield washer fluid pump.
  2. Install a 3 A fused jumper wire between the control terminal A and 12 V. Install a jumper wire between the ground terminal B and ground.
  3. Verify the washer function is activated.
    • If the washer function does not activate, replace the windshield washer fluid pump.
scientia non olet · About LEMON Manuals