LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Wiper System & Washer System) >> Diagnostic Information and Procedures >> Windshield Wiper Washer System Malfunction >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, turn the wipers on low speed; the wipers should activate. If the wipers do not activate, refer to Windshield Wiper System Malfunction .
  2. Turn wipers to the OFF position. Operate the windshield washer using the WASH switch. Verify the washer pump activates.
  3. Observe the scan tool Windshield Washer Switch parameter while cycling the WASH switch ON and OFF. The parameter should cycle between Active and Inactive.
    • If the parameter does not cycle between the specified values, replace the BCM.
scientia non olet · About LEMON Manuals