LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Wiper System & Washer System) >> Diagnostic Information and Procedures >> DTC B3715 >> Component Testing >> Relay Test

Relay Test

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the WPR ON/OFF Relay.
  2. Test for 60-200 ohms between terminals 85 and 86.
    • If the resistance is not within the specified range, replace the relay.
  3. Test for infinite resistance between the following terminals:
    • 30 and 86
    • 30 and 87
    • 30 and 85
    • 85 and 87
    • If not the specified value, replace the relay.
  4. Test for less than 2 ohms between terminals 30 and 87A.
    • If greater than the specified range, replace the relay.
  5. Install a 10A fused jumper wire between relay terminal 85 and 12 volts. Install a jumper wire between relay terminal 86 and ground. Test for less than 2 ohms between terminals 30 and 87.
    • If greater than the specified range, replace the relay.
scientia non olet · About LEMON Manuals