LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement (FE1/FE3) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the front wheels. Refer to Tire and Wheel Removal and Installation .
    3. Fig 1: View Of Stabilizer Bar Mounting Clamp
    GM851715Courtesy of GENERAL MOTORS CORP.
  3. Remove the stabilizer shaft mounting clamp bolts and clamps from both sides of the vehicle.
    4. Fig 2: View Of Stabilizer Bar
    GM851718Courtesy of GENERAL MOTORS CORP.
  4. Remove the bushings from the stabilizer shaft.
scientia non olet · About LEMON Manuals