LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Front Suspension System) >> Repair Instructions >> Lower Control Arm Ball Joint Replacement (with FE1 Only) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ball joint to the lower control arm.
    2. Fig 1: View Of Ball Joint Bolts & Nuts
    GM851730Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the ball joint bolts and the nuts. Follow the instructions in the ball joint kit.

    Tighten:  Tighten the ball joint bolts to 68 N.m (50 lb ft).

  3. Install the lower control arm. Refer to Lower Control Arm Replacement .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals