LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Mechanical - 2.0L) >> Repair Instructions - On Vehicle >> Valve Stem Oil Seal and Valve Spring Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Prevent the crankshaft from rotating clockwise or counterclockwise before using compressed air in the cylinder. Rotation of the crankshaft may cause damage to the J 43653  .
  1. If equipped with a manual transmission, leave the transmission in first gear with the vehicle on the ground and the parking brake set.
  2. If equipped with an automatic transmission, remove the starter. Refer to Starter Replacement .
  3. Install the J 43653  .
  4. Remove the camshaft. Refer to Intake Camshaft and Valve Lifter Replacement  or Exhaust Camshaft and Valve Lifter Replacement .
    5. Fig 1: Identifying Camshaft Roller Followers
    GM758358Courtesy of GENERAL MOTORS CORP.
  5. Remove the camshaft roller followers.
    6. Fig 2: View Of Valve Spring Compressor
    GM758361Courtesy of GENERAL MOTORS CORP.
  6. Install the J 43649  to the cylinder head. See Special Tools .
  7. Remove the spark plugs. Refer to Spark Plug Replacement .
    8. Fig 3: View Of Air Hose Adaptor
    GM758363Courtesy of GENERAL MOTORS CORP.
  8. Install an air hose adaptor into the spark plug hole.
  9. Pressurize the cylinder to 690 kPa (100 psi).
  10. Compress the valve spring.
  11. Remove the valve spring keepers.
  12. Remove the valve spring.
    13. Fig 4: View Of J 36017 & Valve Seal
    GM758364Courtesy of GENERAL MOTORS CORP.
  13. Using the J 36017  , remove the valve seal. See Special Tools .
scientia non olet · About LEMON Manuals