LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Mechanical - 2.0L) >> Repair Instructions - On Vehicle >> Oil Pan Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Oil Pan
    GM1578310Courtesy of GENERAL MOTORS CORP.
  1. Ensure that the oil pan and the sealing surface (1) on the lower crankcase are free of all oil and debris.
    2. Fig 2: Locating Oil Pan Adhesive
    GM854301Courtesy of GENERAL MOTORS CORP.
  2. Apply a 3.5 mm bead of sealant around the perimeter of the oil pan and the oil suction port opening. DO NOT over apply the sealant. Refer to Adhesives, Fluids, Lubricants, and Sealers for the correct part number.
  3. Install the oil pan.
    4. Fig 3: Identifying Oil Pan Bolts
    GM1578309Courtesy of GENERAL MOTORS CORP.
  4. Install the oil pan bolts.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the 4 oil pan to transaxle bolts (1) and tighten to 75 N.m (55 lb ft).
    6. Fig 4: Identifying Oil Pan Bolts Removal & Tightening Sequence
    GM466580Courtesy of GENERAL MOTORS CORP.
  6. Tighten the oil pan bolts in the sequence shown and tighten to 25 N.m (18 lb ft).
  7. Install the lower AC compressor bolt and tighten the upper bolts to 25 N.m (18 lb ft).
  8. Install the engine drive belt. Refer to Drive Belt Replacement .
  9. Lower the engine and install the engine mount. Refer to Engine Mount Replacement .
  10. Remove the engine support fixture.
  11. Lower the vehicle.
  12. Fill the engine with oil to the proper level.
scientia non olet · About LEMON Manuals