LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Mechanical - 2.0L) >> Repair Instructions - On Vehicle >> Oil Level Indicator Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Oil Level Indicator & Tube
    GM1717518Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the oil level indicator tube O-ring seal with lubricant. Refer to Adhesives, Fluids, Lubricants, and Sealers .
  2. Install the oil level indicator tube to the engine block.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the oil level indicator tube bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: Oil Level Indicator Tube And Bracket
    GM2003955Courtesy of GENERAL MOTORS CORP.
  4. Install the vacuum hose (2) to the oil level indicator tube.
  5. Install two wire harness clips (1) to the oil level indicator tube bracket.
  6. Install the CAC outlet pipe. Refer to Charge Air Cooler Outlet Pipe Replacement .
scientia non olet · About LEMON Manuals