LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Mechanical - 2.0L) >> Repair Instructions - On Vehicle >> Engine Front Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Front Cover Bolts
    GM1578292Courtesy of GENERAL MOTORS CORP.
  1. Remove the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
  2. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
  3. Remove the engine front cover bolts.
    4. Fig 2: Engine Front Cover
    GM1578293Courtesy of GENERAL MOTORS CORP.
  4. Remove the engine front cover to water pump bolt.
    5. Fig 3: Engine Front Cover Gasket
    GM1578294Courtesy of GENERAL MOTORS CORP.
  5. Remove and discard the engine front cover gasket.
  6. Remove the crankshaft front cover oil seal with an appropriate tool.
  7. Remove and discard the friction washer.
scientia non olet · About LEMON Manuals