LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Mechanical - 2.0L) >> Repair Instructions - On Vehicle >> Engine Front Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Front Cover Gasket
    GM1578294Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW crankshaft front oil seal. Refer to Crankshaft Front Oil Seal Installation .
  2. Install a NEW friction washer.
  3. Position and install a NEW engine front cover gasket to the dowel pins.
    4. Fig 2: Engine Front Cover Bolts & Long Water Pump Bolt
    GM2146386Courtesy of GENERAL MOTORS CORP.
  4. Install the engine front cover bolts
    5. CAUTION: Refer to Fastener Caution .
  5. Install the long water pump bolt (1)

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  6. Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
  7. Install the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
scientia non olet · About LEMON Manuals