LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Mechanical - 2.0L) >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Crankshaft Rear Oil Seal
    GM412495Courtesy of GENERAL MOTORS CORP.
  1. Use the J 42067  and install the seal. See Special Tools .
    2. Fig 2: Identifying Flywheel & Retaining Bolts
    GM412117Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the flywheel and tighten to 53 N.m (39 lb ft) plus 25 degrees.
  3. Install the transmission. Refer to Transmission Replacement .
scientia non olet · About LEMON Manuals