Engine Front Cover and Oil Pump Installation

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Front Cover & Gasket

Courtesy of GENERAL MOTORS CORP.

Install the engine front cover (1) with a new gasket (2).

Fig 2: Engine Front Cover Bolts & Long Water Pump Bolt

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

NOTE: The center bolt (1) should be tightened last.

Install the engine front cover bolts and tighten to 25 N.m (18 lb ft).
Install the long water pump bolt (1) and tighten to 25 N.m (18 lb ft).

Fig 3: View Of Drive Belt Tensioner

Courtesy of GENERAL MOTORS CORP.

Install the accessory drive belt tensioner.
Install the accessory drive belt tensioner bolt and tighten to 45 N.m (33 lb ft).