LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Mechanical - 2.0L) >> Repair Instructions - Off Vehicle >> Engine Block Disassemble

Engine Block Disassemble

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Passage Plug, Oil Flow Check Valve & Water Jacket Drain Plug
    GM412447Courtesy of GENERAL MOTORS CORP.
  1. Remove the water jacket drain plug.
  2. Remove the oil flow check valve.
  3. Remove the rear oil passage plug.
  4. Remove the 6 oil passage plugs on the sides of the block.
  5. Remove the 2 water passage plugs on the top of the block.
  6. Remove the 2 front oil passage plugs.
    7. Fig 2: Knock Sensors
    GM1769811Courtesy of GENERAL MOTORS CORP.
  7. Remove the knock sensors.
    8. Fig 3: Oil Pressure Switch
    GM1825051Courtesy of GENERAL MOTORS CORP.
  8. Remove the oil pressure switch.
    9. Fig 4: CKP Sensor
    GM1825052Courtesy of GENERAL MOTORS CORP.
  9. Remove the crankshaft position (CKP) sensor and bolt.
    10. Fig 5: Piston Oil Squirter
    GM1594334Courtesy of GENERAL MOTORS CORP.
  10. Loosen the piston oil nozzle assembly captured bolts and remove the piston oil nozzle assemblies.
scientia non olet · About LEMON Manuals