LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Mechanical - 2.0L) >> Repair Instructions - Off Vehicle >> Engine Block Assemble

Engine Block Assemble

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Passage Plug, Oil Flow Check Valve & Water Jacket Drain Plug
    GM412447Courtesy of GENERAL MOTORS CORP.
  1. Apply sealant to the water pump drain plug before installation. Refer to Adhesives, Fluids, Lubricants, and Sealers .
  2. Install the drain plug in the water pump.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the coolant jacket plugs and tighten to 35 N.m (26 lb ft).
  4. Apply sealant to the plugs before installation. Refer to Adhesives, Fluids, Lubricants, and Sealers .
  5. Install the rear oil passage plugs. Tighten the oil passage plug to 60 N.m (44 lb ft).
  6. Install the other oil passage plugs. Tighten the oil passage plugs to 35 N.m (26 lb ft).
    7. Fig 2: CKP Sensor
    GM1825052Courtesy of GENERAL MOTORS CORP.
  7. Lubricate the crankshaft position (CKP) sensor O-ring with clean engine oil.
  8. Install the CKP sensor and bolt and tighten to 10 N.m (89 lb in).
    9. Fig 3: Oil Pressure Switch
    GM1825051Courtesy of GENERAL MOTORS CORP.
  9. Install the oil pressure switch and tighten to 26 N.m (19 lb ft).
    10. Fig 4: Knock Sensors
    GM1769811Courtesy of GENERAL MOTORS CORP.
  10. Install the knock sensors and bolts. Tighten the knock sensor bolts to 25 N.m (18 lb ft).
    11. Fig 5: Piston Oil Squirter
    GM1594334Courtesy of GENERAL MOTORS CORP.
  11. Install the piston oil nozzle assemblies.
  12. Install the piston oil nozzle assembly bolts and tighten to 15 N.m (11 lb ft).
scientia non olet · About LEMON Manuals