LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Battery, Charging System And Starting System) >> Repair Instructions >> Starter Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Harness Terminal To Starter
    GM1656131Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the starter solenoid terminal nut (5).
  4. Remove the positive battery cable terminal (4) from the starter.
  5. Remove the starter solenoid wire terminal (3) from the starter.
  6. Disconnect the engine harness connector (1) from the starter.
    7. Fig 2: Identifying Starter Bolts & Starter
    GM1648192Courtesy of GENERAL MOTORS CORP.
  7. Remove the starter bolts.
  8. Remove the starter.
scientia non olet · About LEMON Manuals