LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Replacement (Battery to Battery Tray) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Battery Connections
    GM1656237Courtesy of GENERAL MOTORS CORP.
  1. Install the negative battery cable (3). Ensure that the anti-rotation tab on the terminal (5) is correctly located.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the negative battery cable ground bolt (4) and tighten to 17 N.m (13 lb ft).
  3. Connect the body harness electrical connector (7) to the battery current sensor (6).
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals