PNP Switch (MN5 4T45-E)
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the PNP switch.
- With the PNP switch in the following positions, test for infinite resistance between the ground terminal 1 and the signal terminal 12.
- R
- OD
- D
- 2
- 1
- If not the specified value, replace the PNP switch.
- With the PNP switch in the following positions, test for less than 2 ohms between the ground terminal 1 and the signal terminal 12.
- P
- N
- If greater than the specified range, replace the PNP switch.