Manual Transmission (M86/MU3)
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, observe the scan tool ECM CPP Sensor and the CPP Learn Status parameters. The scan tool CPP Sensor parameter should change when the clutch pedal is pressed and released, and the CPP Learn Status should be Complete.
- If not the specified values, refer to the appropriate procedure listed below:
- Clutch Pedal Position Sensor Learn for the Getrag (M86) transmission
- Clutch Pedal Position Sensor Learn for the Saab (MU3) transmission
- If not the specified values, refer to the appropriate procedure listed below:
- Command the Starter Relay ON with a scan tool (L61/LNF), or turn the ignition switch to the START position (LE5). The starter solenoid should engage and the engine should crank.
- If the solenoid engages but the engine does not crank, refer to Starter Solenoid Clicks, Engine Does Not Crank .
- If the solenoid does not engage, refer to CRNK Relay Circuit Malfunction.